1.PRECISE CUT OFF LENGTH SETTING:
The touch sensitive control screen located at the operator's station provides easy selection of precise bar length requirement. The readout is calibrated in 0.10mm or 0.01ins increments
2.AUTO HEAD-ELEVATION AND QUICK APPROACH:
Raising the blade higher than necessary to clear the workpiece for the next cut wastes time. Head elevation is controlled automatically and no longer requires the operator's attention. A control device that senses the size of the workpiece, permits the saw head to raise just high enough so the blade clears the material. This reduces index cycling time significantly.
3.INFINITELY VARIABLE BLADE SPEED:
The Blade speed is set and adjusted on the touch sensitive control screen. Simply select the speed you require, it is set automatically via the frequency inverter.
It’s easy to program multiple lengths and quantities on the user friendly touch screen, if lengths above 400mm (16ins) are required, just enter the length you need, and the machine will calculate the number of feeds required.
5.QUICK-ADJUSTING CARBIDE SAW-BAND GUIDES:
For the replacement of the saw blade or the repositioning of the guide arms. Two thumb screws are incorporated in the saw guides to allow these operations to be carried out quickly and efficiently.
6.IDLE WHEEL MOTION DETECTOR:
This device not only can protect the saw blade from damage if the blade overloads during cutting, but will also shut off the machine if the blade should break.
7.HYDRAULIC BAND TENSION CONTROL:
When a blade is fitted the correct tension is applied hydraulically and during operation of the saw the correct tension is automatically maintained. The tension is reduced when the saw is shut-off. This procedure greatly increases blade life.
8.QUICK-ACTION HYDRAULIC TWIN-VICE (SPLIT VICE) 3-JAW CLAMPING:
Materials are firmly clamped on both sides of the saw blade by twin vices. Operating a single switch provides manual or automatic clamping and unclamping of materials. These unique twin vices allow automatic bar feed and cutting to within as little as 32mm of the bar end and also reduces burrs on the cut component
9.UNIQUE TWO-WAY VICE JAW:
Both vice jaws on the rear carriage are open and closed simultaneously, unlike the traditional method which only opens one vice. This feature is designed to handle stock material that may not be completely straight.
10.AUTOMATIC CHIP CONVEYOR:
A power driven brush keeps the saw blade free of chips while a rotating screw propels the swarf up a chute and out of the machine.