Downloads: Information Sheet
Please note: All the information about machines listed on this website is subject to change and should not be relied upon without verification from our sales staff.
The touch sensitive control screen located at the operator's station provides easy selection of precise bar length requirement. The readout is calibrated in 0.10mm or 0.01ins increments
Raising the blade higher than necessary to clear the work for the next cut wastes time. Head elevation is controlled automatically and no longer requires the operator's attention. A control device that senses the size of the work-piece, permits the saw head
to raise just high enough so the blade clears
the work. This reduces index cycling time significantly.
The Blade speed is set and adjusted by acting on the touch sensitive control screen. Simply select the speed you require, it is set automatically via the frequency inverter.
It’s easy to program multiple lengths and quantities on the user friendly touch screen, if lengths above 400mm (16ins) are required, just enter the length you need, and the machine will calculate the number of feeds
For the replacement of the saw blade or the repositioning of the guide arms. Two thumb screws are incorporated in the saw guides to allow these operations to be carried out quickly and efficiently.
This device not only can protect the saw blade from damage if the blade overloads during cutting, but will also shut off the machine if the blade should break.
When a blade is fitted the correct tension is applied hydraulically and during operation of the saw the correct tension is automatically maintained. The tension is reduced when the saw is shut-off. This procedure greatly increases blade life.
Materials are firmly clamped on both sides of the saw blade by twin vices. Operating a single switch provides manual or automatic clamping and unclamping materials. These unique twin vices allow automatic bar feed and cutting to within as little as 50mm of bar end and also reduces burrs on the cut component
Both vice jaws on the rear carriage are open and closed simultaneously, unlike the traditional method which only opens one vice. This feature is designed to handle stock material that may not be completely straight.
A power driven brush keeps the saw blade free of chips while a rotating screw propels the swarf up a chute and out of the machine
|Operation||Automatic, Horizontal, Pivot Action,|
|Cutting Type||Bundle Cutting,|
|Materials||Solids, Sections, Aluminium, Nickel Alloys, Ferrous, Non-Ferrous,|
|Blade Size||4110 x 34 x 1.1|
|Blade Speed||60 HZ 20 ~ 85 m/min|
|Dimensions||2215 x 1400 x 2040|
|Motor||5 HP x 4P|
|Hydraulic System||Motor: 1 HP x 4P Tank: 40 Litres|
|Coolant System||Motor: 1/6 HP x 4P Tank: 60 Litres|
Call us during office hours (8:30am – 5pm, Mon – Fri) for assistance with choosing the best machine for the job.