Downloads: Information Sheet
Please note: All the information about machines listed on this website is subject to change and should not be relied upon without verification from our sales staff.
A convenient digital readout control located at the operator's station provides easy selection of precise bar length requirement. The digital readout is calibrated in 0.10 mm or 0.01 IN increments and can be repositioned without interrupting the cutting cycle.
Raising the blade higher than necessary to clear the work for the next cut wastes time. Head elevation is controlled automatically and no longer requires the operator's attention. A control device that senses the size of the workpiece, permits the saw head to raise just high enough so the blade clears the work. This reduces index cycling time significantly.
The hydraulically-operated nesting fixture is designed for high-production multiple sawing of stacked bars, small rounds and tubing. The fixture contains vertical cylinders mounted on the index and front vices. lt holds stacked work firmly to assure accurate cuts and prevent centre bars from turning.
The cutting piece counter is used to preset the number of cuts required on automatic operation. When the counter reaches the preset number the saw automatically stops. The multiple stroke counter makes it possible to multiply the number of index cycles when pieces longer than 400mm (16in) are required.
For the replacement of the saw blade or the repositioning of the guide arms. Two levers are incorporated in the saw guides to allow these operations to be carried out quickly and efficiently. (Hydraulic carbide guides on 550/700 models)
This device not only can protect the saw blade from damage if the blade overloads during cutting, but will also shutoff the machine if the blade should break.
During operation of the saw the correct tension is automatically maintained. The tension is reduced when the saw is shut-off. This procedure greatly increases blade life.
Materials are firmly clamped on both sides of the saw blade by twin vices. Operating a single switch provides manual or automatic clamping and unclamping materials. These unique twin vices allow automatic bar feed and cutting to within as little as 50mm of bar end.
Both vice jaws on the rear work-carriage are actuated simultaneously, opening or closing, instead of the traditional one that is fixed on one side, moveable on another. This particular design ensures accurate indexing even with warped stock.
A power driven brush keeps the saw teeth free of chips. Rotating screw shaft in the coolant return drains chips of cutting fluid and propels dry chips by auger conveyor out through a discharge chute.
|Operation||Automatic, Horizontal, Pivot Action,|
|Materials||Solids, Sections, Plastics, Aluminium, Nickel Alloys, Ferrous, Non-Ferrous,|
|Blade Size||3810 x 34|
|Dimensions||2100 x 2100 x 1500|
Call us during office hours (8:30am – 5pm, Mon – Fri) for assistance with choosing the best machine for the job.